The GE Fanuc IC200ERM002 Non-Isolated Expansion Module is a product of GE Intelligent Platforms/GE Fanuc.

It is manufactured as part of the Versamax series to enhance the functionality of a PLC or I/O output station and increase the number of modules that can be connected.

About the IC200ERM002

The GE Fanuc IC200ERM002 module is a non-isolated expansion receiver module that is part of the Versamax family.

This expansion module is used to enhance the functionality of a Versamax PLC or I/O output station and also increases the number of modules that can be connected.

The IC200ERM002 Expansion Module has a **capacity of 7 racks with up to 8 modules per rack*.

It requires an installed power supply to power all connected devices.

When an additional power supply or booster carrier is used, it should be connected to www.abb-drive.com the mains power supply on the IC200ERM002 Expansion Module.

It also features 3 on-board LEDs to indicate the operational status of the device.

The module can also be used as a single-ended or multi-rack Versamax I/O expansion system.

Where the module is used in a multi-rack implementation, the total cable length cannot exceed 50 feet or 15 meters.

When the Versamax GE Fanuc IC200ERM002 Non-Isolated Expansion Receiver Module is used in a single-ended system with only 1 expansion rack, the

The cable length should not exceed 3.3 feet or 1 meter.

It has a data rate of 2.765 Mbps or 5 Mbps, depending on the implementation used.

The GE Fanuc IC200ERM002 expansion module is equipped with two 26-pin D-shell expansion female ports.

In addition, it has two different current consumption ratings with a 3.3 volt or 5 volt backplane rating.

When the backplane voltage is 5 volts, the current consumption is rated at 70 milliamps and when the backplane voltage is rated at 20.3 volts, the current consumption is rated at 3 milliamps.